Elgar CW 801P-V Betriebsanleitung PDF herunterladen (Seite 43)

Elgar CW-M Series

5 OPERATION

The controls and indicators for the CW series power source are detailed below.

Refer to Figure 5–1.

Figure 5–1 CW Front Panel Controls

POWER SWITCH

Press the top portion of the switch to turn power on, press the bottom portion of

the switch to turn the power supply off. When power is turned on, the unit goes

through a power up cycle that may take several seconds before it is ready for

operation.

VOLTAGE CLUSTER

These five controls and indicators, located on the left side of the front panel,

are used to select and display the power supply’s output voltage.

V RANGE HIGH/LOW Switch. This switch allows you to select the

0V-135V range or the 0V-270V range of output voltage. The output current

available on the low voltage range is twice that available on the high voltage

range.

This switch should not be toggled while the system output is turned on. Doing

so will cause the output to turn off, and a fault condition will be indicated.

CAUTION!

To protect the load, ensure that the output of the

CW unit is turned off before using the V RANGE switch.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Keine Kommentare

Elgar CW 801P-V Betriebsanleitung Seite 43