Elgar CW 1251P-V Spezifikationen PDF herunterladen (Seite 45)

Elgar CW-P Series Installation

Operation Manual 2-23

54. On the C slave CW press the ENTER/SAVE button.

55. Rotate the left knob until the left display reads “Addr”.

56. Rotate the right knob until the right display reads “1”.

57. Press the ENTER/SAVE button.

58. Press the ENTER/SAVE button.

59. Rotate the left knob until the left display reads “ChAn”.

60. Rotate the right knob until the right display reads “C”.

61. Press the ENTER/SAVE button.

62. Power down six CW power supplies.

63. Connect Elgar cable 890-497-40 between the A master “Analog Slave” and the

A slave “Analog Slave” connectors.

64. Connect Elgar cable 890-497-40 between the B master “Analog Slave” and the

B slave “Analog Slave” connectors.

65. Connect Elgar cable 890-497-40 between the C master “Analog Slave” and the

C slave “Analog Slave” connectors.

66. Connect up all of the daisy chained cables. The unit order is suggested below in

steps 67 through 71. As long as A master is the origin, all other daisy chained

units can be in any order.

67. Connect the Elgar cable 890-499-00 between the A master “M/S OUT” and the

A slave “M/S IN”.

68. Connect the Elgar cable 890-499-00 between the A slave “M/S OUT” and the

B master “M/S IN”.

69. Connect the Elgar cable 890-499-00 between the B master “M/S OUT” and the

B slave “M/S IN”.

70. Connect the Elgar cable 890-499-00 between the B slave “M/S OUT” and the

C master “M/S IN”.

71. Connect the Elgar cable 890-499-00 between the C master “M/S OUT” and the

C slave “M/S IN”.

72. Connect the load wiring as shown in Figure 3–12 above.

73. Power up six CW units simultaneously.

74. Control the master/slave array by controlling the CW A master via the front panel

or its command interface.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Keine Kommentare

Elgar CW 1251P-V Spezifikationen Seite 45